Diagram Plus guide

This low cost bass treble circuit consists of some capacitors, resistors, and two T/C pot for BASS and TREBLE control. this circuit can be made without even a veroboard. You just solder components as this circuit network is not so complex. It has only two-pin parts. Let’s take a look at he circuit diagram. Nothing to say about it, as it is so simple that a beginner level hobbyist can even understand and build this circuit.


But there are some -ve points of this circuit which I must say, after giving you the circuit. As no external power supply, the O/P power is much lesser than I/P power, so volume decreases. The treble control doesn’t act as linear, it increases treble a lot in the end pot side

Shiftlight does not respond to buttons being pressed. The engine must be running in order to set the pre-shift and shift points on the shiftlight. The unit requires an input signal (tachometer, coil negative, crank angle sensor)if there is no input signal the unit will not respond whenbuttons pressed. MITSUBISHI RVR N23W 4G63 1992 – 97 GM – 2 President G50 VH45DE 1990 – GN – 4 Infinity Q45 G50 VH45DE 1989 – 97.

Pajero V23W 6G72 1991 – GM – 2 N74W 4G64 GM – 3 N73W 4G63 M/T GM – 3 N71W 4G93 N61W 1997 – GM – 3 Cinma III FGY33 VH41DE 1996 – 98 GN – 6 FHY33 VQ30DET GN – 5 Cinma II FGY32 VH41DE 1991 – 96 GN – 4 FPY32 VG30DET 1993 – 96 Cinma I FPY31 VG30DET 1989 – 91 FPY31 VG30DE FPY31 VG30DET 1988 -89 GN – 1 FPY31 VG30DE.

get here